Please select filters
Product Type
Eraser
Eraser
Application
Elegant writing instruments - Write to create
Elegant writing instruments - Write to create
Product Line
e-motion
Clear all filters 1 products
Erasers and other correcting equipment

Rubbers / kneaded erasers / rubbers / eraser pencils

Filters
1 products

General information on Faber-Castell erasers and correct use

The quality of the eraser and using the correct eraser for the relevant use are key for achieving optimal results. Soft erasers are ideal for removing strokes that go no deeper than the surface of the paper (pencil strokes, shadings in coloured pencil). Hard erasers are used for removing strokes that have penetrated deep into the paper (e.g. drawn with a fountain pen, gel pens, ballpoint pens). The eraser contains a fine abrasive material (e.g. quartz powder), which scratches a thin layer off the surface. Pencil strokes are always easier to erase than coloured pencil strokes, because graphite does not bond as strongly with the paper fibres. The eraser should be positioned at an angle to the stroke, as parallel movements could initially cause the stroke to smudge.

We have a product in the product range to suit every application. From erasers for homework, to high-quality art erasers used by artists. All rubber erasers and a large proportion of the plastic erasers produced by Faber-Castell are LATEX-free and PVC-free. The well-balanced plastic mixture of the quality erasers guarantees soft and smudge-free erasing action.

History of the eraser

When erasing large areas of graphite, particularly with writing or stroke areas running over several lines, the eraser can often start to 'smudge'. This is because the user tries to erase too quickly and the parts of the eraser have to absorb too much graphite. The eraser can only carry out its task if the movements create a balanced ratio between graphite-free areas and areas containing graphite. The eraser can not become "overloaded"! Erasing parallel to the stroke: Area becomes dirty, erasing is slowed down unnecessarily! Erasing at an angle to the stroke: Erasing the area bit by bit clears the area quickly and effectively!

Erasing correctly

When erasing large areas of graphite, particularly with writing or stroke areas running over several lines, the eraser can often start to 'smudge'. This is because the user tries to erase too quickly and the eraser bits have to absorb too much graphite. The eraser can only carry out its task if the movements create a balanced ratio between graphite-free areas and areas containing graphite. The eraser cannot become "overloaded"! Erasing parallel to the stroke: Area becomes dirty, erasing is slowed down unnecessarily! Erasing at an angle to the stroke: Erasing the area bit by bit clears the area quickly and effectively!